top of page

Sharps Safety in Dental Practices: What CQC Expects

Writer: Liam
Liam
6 days ago
4 min read
Dentist in navy scrubs disposing of a used needle into a yellow sharps container on a work surface, while a dental nurse in teal scrubs looks on
Illustration: safer sharps and a container at the point of use are central to preventing inoculation injuries.

Sharps safety in dental practices is about preventing inoculation injuries, not just putting a bin on the bracket table. Drawing on my 12 years as a CQC inspector, I explain the legal duties I would expect a practice to demonstrate, and how I would test them.


The Health and Safety (Sharp Instruments in Healthcare) Regulations 2013 apply to healthcare employers, which includes dental practices. CQC reviews this when it looks at whether a practice is safe, under Regulation 12 (safe care and treatment) and Regulation 15 (premises and equipment). Dental mythbuster 7 sets out what CQC expects.


Avoid unnecessary sharps and use safer devices


Regulation 5 requires employers, so far as is reasonably practicable, to avoid the use of medical sharps and, where sharps are used, to use safer sharps. A safer sharp is designed with a feature or mechanism that prevents or minimises the risk of accidental injury, such as a shield that covers the needle after use.


This is not a blanket ban on every traditional device. If the practice continues to use traditional unprotected sharps, including reusable local anaesthetic syringes, I would expect a written policy and a risk assessment that explains why a suitable safer alternative is not reasonably practicable. CQC describes single-use disposable local anaesthetic syringes with a protection mechanism as best practice.


Needles must not be recapped after use unless a risk assessment under the Management of Health and Safety at Work Regulations 1999 has identified that recapping is itself required to control a risk, and a suitable device, such as a needle-block for one-handed recapping, effectively controls the risk of injury. Two-handed recapping is a well-recognised cause of injury and should not be a routine habit.


Dispose of sharps at the point of use


Clearly marked, secure containers and written instructions for employees must be located close to the areas where medical sharps are used. CQC is explicit that those containers should not be sited on the floor.


I would look at whether the person using the sharp can dispose of it immediately, without walking across the surgery or passing it to a colleague. Overfilled or poorly positioned containers create avoidable risk. Employers must also review their policies and procedures at suitable intervals so they remain up to date and effective.


Train people on the equipment they actually use


Employees who may be injured by medical sharps must be given information and training relevant to their work. I would expect this to cover the specific devices in use, safe handling and disposal, and exactly what to do if someone is injured, including who to notify and how to do so promptly, including out of hours if relevant.


CQC may ask staff to describe the needlestick procedure. A policy that only exists in a folder is not enough if people cannot explain it.


Have a clear procedure for inoculation injuries


An injured employee must notify their employer as soon as practicable. The employer must record the incident, investigate the circumstances and cause, and take any action needed to prevent a recurrence.


The investigation should be proportionate. An injury with a clean needle as it is removed from the packet will usually need a record and any first aid required. An injury involving a used needle needs more analysis, and an appropriate record of the findings should be kept.


Where a sharp has, or may have, exposed the person to a blood-borne virus or other biological agent, the employer must take immediate steps to ensure they receive medical advice, make available any treatment advised by a registered medical practitioner, including post-exposure prophylaxis, and consider counselling. CQC recommends a wall-mounted flowchart in the practice that sets out the process and the contact numbers for occupational health or A&E.


I would also expect the team to understand that information about a source patient, if it can be established, must be handled in line with patient confidentiality and shared promptly with the clinician treating the injured person.


What I would check under Regulation 12


When I inspected, I would start with the risk assessment and written sharps policy, then look at what happens in the surgeries. Are safer sharps in use where it is reasonably practicable? If not, is the justification documented and still valid? Are sharps bins close to the point of use, off the floor and not overfilled? Can staff, including nurses and visiting clinicians, describe the injury procedure without hesitation?


Regulation 12 requires care and treatment to be provided safely, including assessing and controlling the risk of infection. Sharps injuries are one of the practical tests of whether that system works. For the wider infection prevention arrangements that sit alongside this, see my guide to dental infection control and HTM 01-05.


If you want an independent review of your sharps arrangements, staff understanding and documentation, my CQC compliance support can help identify practical gaps before an inspection or an injury exposes them. A dental mock inspection is another way to test whether the team can explain the procedure in practice.


Sources and further reading






 
 
 

Comments


bottom of page